Download armor measurement form here!
Generic coach measurement instructions
Click here for tips on how to take useful coach photos
Sample measurement form for 44B
Sample measurement form for 42RBQ
Entegra Anthem
There are a few areas on the Entegra Anthem that require special attention. These will require additional measurements.
Wheel well panels
Measure from the edge of the panel to the crease where the flare starts as shown below
On the rear driver side panel you need to measure
A. From the left edge to the where the fin bends
B. From the right edge to the fin opening
C. The overall width of the panel measured horizontally
If you are getting full height grill caps we need the following measurements
A. Height of the leftmost fin
B. Height of the rightmost fin
C. Distance from bottom of left fin to the CENTER of the horizontal support
D. Distance from bottom of right fin to the CENTER of the horizontal support
On the front driver side panel you will need the following measurements
A. from the front cap molding to the left edge of the door opening
B. from the front cap molding to the right edge of the door opening
C. from the front cap molding to the wheel well flare across from the bottom of the door
D. the width of the door panel
On the rear passenger side panel you will need to measure the following
A. height of the panel along the left edge
B. height of the panel along the right edge
C. width of the panel measured horizontally (not along the angle)
Measure your step surround according to the instructions and diagram below
A is the distance from the top of the opening on the left side to the bottom of the door molding
B is the same thing but on the right side of the opening
C is the distance from the left edge of the opening to the start of the wheel flare
D is the distance from the right edge of the opeining to the front cap molding
E is the distance from the front cap molding to the left edge of the opening
If you can’t view the above image clearly try using Chrome or right clicking it to “save picture” and then view the downloaded picture.
During installation the right leg of the surround should be formed by hand to match the curve in the fiberglass. Most installers will just form this part over their knee.