Tour

Download armor measurement form here!

Generic coach measurement instructions

Click here for tips on how to take useful coach photos

Winnebago Tour

There are a few areas on the Tour that require special attention.  These will require additional measurements.

NOTE: These panel numbers are a general guide, you may end up with more or fewer panels and this is okay.

Starting with the passenger side! (P-Panels)

P1 is the panel behind the front tire.  Measure from the left edge to the wheel opening near the bottom where it is closest to vertical.

P2-7 are the straight panels in between the wheels, measure the actual length of the panels

P8 is the panel in front of the rear wheels. Measure from the right edge to the wheel opening near the bottom where it is closest to vertical.

P9 is the panel behind the rear tire.  Measure from the left edge to the wheel opening near the bottom where it is closest to vertical.

P10 is the angled rear panel.  See the diagram below to find the measurements we need.  Measurement A is the length horizontally (don’t follow the bottom angle).  Measurements B and C are the height of the door at the front and rear of the panel.  These will give us the correct angle.  If there are more than one angled bottom door in a row please contact us for further instruction.

reardoor

Now for the driver side (D-Panels)

D1 is the narrow front panel.

D2 is the door in front of the front wheel.

D3 is the narrow wheel well panel in front of the front wheel.  Measure from the left edge to the wheel opening near the bottom where it is closest to vertical.

D4 is the panel behind the front wheel.  Measure from the right edge to the wheel opening near the bottom where it is closest to vertical.

D5-D11 are all straight panels.

D12 is the panel in front of the rear wheels.  Measure from the left edge to the wheel opening near the bottom where it is closest to vertical.

D13 is the panel behind the rear wheels.  Measure from the right edge to the wheel opening near the bottom where it is closest to vertical.

D14 is the rear angled panel.  See the diagram below to find the measurements we need.  Measurement A is the length horizontally (don’t follow the bottom angle).  Measurements B and C are the height of the door at the front and rear of the panel.  These will give us the correct angle.

IMAG0187

 

Information for installers