NOTE: These panel numbers are a general guide, you may end up with more or fewer panels and this is okay.
P1 is the panel right in front of the front wheel. Measure the distance from the left edge of the step opening to the wheel well.
P2 is the panel right behind the front wheel, measure from the left edge to the inside of the wheel well.
P3 through P8 are straight panels. Measure full width.
P9 is directly in front of the rear wheels. Measure from the right edge to the wheel well. We do not require measurements for the light cutout.
P10 is the panel behind the rear wheels, measure form the left edge to the wheel well.
P11 – P13 you will measure horizontally across each door separately first. P13 is the narrow space between the rear door and the molding.
Then you need to provide a sketch with 3 measurements as shown below so we can get the correct angle on the panels. A vertical measurement in the front of P11, and the rear of P13, and also a horizontal measurement across all 3 panels. For the vertical measurements hook your tape measure on the bottom edge of the door and measure up to the top.
D1 is the narrow strip between the front door and the molding
D2 is the door in front of the front wheel
D3 and D4 are the wheel well panels, measure the same way you did on the other side.
D5 through D11 are straight panels. Measure full width.
D12 and D13 are wheel well panels, measure the same as you did on the other side.
D14 is the rear grill panel, we will need the following measurements (see pic)
A is the overall length measured horizontally.
B is the width of the left edge
C is the width of the right edge
D15 is the narrow piece in front of the molding