Download armor measurement form here!
Generic coach measurement instructions
Click here for tips on how to take useful coach photos
Tiffin Allegro Bus
There are a few areas on the Allegro Bus that require special attention. These will require additional measurements.
NOTE: These panel numbers are a general guide, you may end up with more or fewer panels and this is okay.
Panels adjacent to the wheels will need to be measured from the straight edge over to the crease of the wheel flare. The example below would indicate a measurement of 4 3/4″
Starting with the passenger side!
P1 is behind the front wheel. Measure from the left edge to the crease of the wheel flare
P2-P7 will be straight panels. Measure the actual length
P8 is a wheel well panel. Measure the same as you did P1
P9 goes behind the rear wheels as shown below. Measure from the wheel flare crease to the rear molding.
Now on to the drivers side!
D1 has a door in it so we will need measurements A through D as shown below. Note A through C are all measured from the left edge
D2 will be behind the front wheel, measure from the right edge to the wheel flare crease
D3-8 will be straight panels. Measure the actual length
D9 will be in front of the rear wheels, measure from the right edge to the wheel flare crease
D5-D10 are regular baggage doors
D11 is the wheel well panel in front of the rear wheels
D12 is the wheel well panel behind the rear wheels, measure from the flare crease to the left edge of the radiator opening (should only be a few inches or so)
D13 is the last panel, this is the width of the area behind the grills. Measure from the right edge of the radiator opening to the rear molding (should only be a few inches or so)
For grill cap measurements you must provide us with measurements A through E according to the diagram below.
Download the full size picture HERE