Download armor measurement form here!

Generic coach measurement instructions

Click here for tips on how to take useful coach photos

Sample for 44B

 

Entegra Cornerstone

There are a few areas on the Entegra Cornerstone that require special attention.  These will require additional measurements.

Wheel well panels

Measure the full width of the panel from the point right above the bottom curve

On the rear driver side panel you need to measure

A. From the left edge to the where the fin bends

B. From the right edge to the fin opening

C. The overall width of the panel measured horizontally

Download drawing here

If you are getting full height grill caps we need the following measurements

A. Height of the leftmost fin

B. Height of the rightmost fin

C. Distance from bottom of left fin to the CENTER of the horizontal support

D. Distance from bottom of right fin to the CENTER of the horizontal support

On the front driver side panel you will need the following measurements

A. from the front cap molding to the left edge of the door opening

B. from the front cap molding to the right edge of the door opening

C. from the front cap molding to the wheel well measured across from the bottom of the door

D. the width of the door panel

Download drawing here

On the rear passenger side panel you will need to measure the following

A. height of the panel along the left edge

B. height of the panel along the right edge

C. width of the panel measured horizontally (not along the angle)

Download drawing here

Measure your step surround according to the instructions and diagram below

A is the distance from the top of the opening on the left side to the bottom of the door molding

B is the same thing but on the right side of the opening

C is the distance from the left edge of the opening to the start of the wheel flare

D is the distance from the right edge of the opeining to the front cap molding

E is the distance from the front cap molding to the left edge of the opening

During installation the right leg of the surround should be formed by hand to match the curve in the fiberglass.  Most installers will just form this part over their knee.