Bounder | Summit

Fleetwood Bounder Tips

If these panel descriptions don’t seem to match what you have on your coach, please send us some photos and we will create some new instructions for you.

Starting on the front drivers side

D1 is the length of the door in front of the front wheel

D2 and D3 are the narrow panels in front of and behind the front wheels. Measure the full width

D4 through D7 are straight doors, just measure the overall length of each (you may have more panels here, adjust panel numbers accordingly)

D8 and D9 are the narrow panels in front of and behind the rear wheels. Measure the full width

D10 is the straight door behind the rear wheels (you may also have another small straight section in front of the door)

D11 is the long angled door, we extra measurements to make sure we get the angle correct. Please provide the horizontal length of the door A as well as the door height at the front and rear edges B and C.

On the passenger side:

P1 is the width of the panel that will go on the front of the entry steps (skip if you are getting a step surround)

P2 is the width of the panel that will go behind the entry steps (skip if you are getting a step surround)

P3 is the panel behind the front wheel. Measure the full width

P4 through P8 are straight doors, just measure the overall length of each (you may have more panels here, adjust panel numbers accordingly)

P9 and P10 are the narrow panels in front of and behind the rear wheels. Measure the full width

P11 is the straight door behind the rear wheels (you may also have another small straight section in front of the door)

P12 is the long angled door, we extra measurements to make sure we get the angle correct. Please provide the horizontal length of the door A as well as the door height at the front and rear edges B and C.

Information for installers