Download armor measurement form here!
Generic coach measurement instructions
Click here for tips on how to take useful coach photos
Monaco Dynasty
There are a few areas on the Monaco Dynasty that require special attention. These will require additional measurements.
Do not worry if the panel numbers in these drawings don’t match what you put on your measurement form. Different coaches will have different door layouts
If you are getting a step surround we will need some measurements as shown below.
A is from the left edge of the opening straight across to the edge of the wheel opening, measured straight across from the top of the opening
B and C are the distance from the top of the opening to the bottom of the door molding (they may or may not be the same)
D is the width of the step opening
If you have the small door on the D9 panel we will need measurements off of that also
A is the distance from the left edge of the panel to the right edge of the door molding
B is the distance from the left edge of the panel to the left edge of the door molding
C is the width of the face of the door
D is the distance from the left edge of the door face to the center of the lock cylinder
E is the distance from the bottom edge of the door face to the center of the lock cylinder
F is the distance form the middle of the bend in your panel up to the bottom of the door molding
G is the overall width of the panel measured at the bend line
The rear passenger panel will need measurements for the door cutout also, please refer to the drawings below
A is the distance from the panel bend up to the bottom of the door opening
B is the distance straight across from the bottom of the door opening to the edge of the wheel opening
C is the overall width of the door opening
D is the width of just the door
E is the distance from the left edge of the door to the left edge of the door latch
F is the distance from the bottom of the door to the bottom of the door latch
On the front driver side panel we will need measurements for the door cutout and the latch within the door. See drawings
A is the distance from the right edge of the door cutout to the edge of the wheel opening, measured along the bottom edge of the door.
B is the distance from the lower bend up to the bottom of the door cutout at the left edge of the door
C is the distance from the lower bend up to the bottom of the door cutout at the right edge of the door
D is the width of the door cutout
E is the width of the door face
F is the distance from the bottom of the door face to the bottom of the latch
G is the distance from the right edge of the door face to the right edge of the latch
The rear driver side panel under the grill will need a few measurements also.
A is the overall length, the panel will en at the right edge of the grills
B is the height from the lower bend up to the bottom of the grills
C is the distance from the left edge to the point where the angle begins
D is the height of the right edge from the bend up to the grill
